Grounding of the units: Attach a ground wire from one of the threaded studs (A) at the bottom of the housing, to the mounting plate (B). This helps to reduce the potential difference that exists between conductive parts and the earth. Equipment Protection: Grounding protects substation. This technical article covers protective grounding requirements for steel tower and wood pole supported transmission and distribution lines, and insulated power cables. Protective grounds must be installed so all phases of lines or cable are visibly and effectively bonded together in a multi-phase. Power from factory ground must be installed by a qualified electrician. Each DISTRIBUTION BOX and controller must be grounded. Whether you're a seasoned pro or just starting out, this comprehensive guide will give you practical.
[pdf] Distributed temperature sensing systems (DTS) are optoelectronic devices which measure temperatures by means of optical fibres functioning as linear sensors. Temperatures are recorded along the optical sensor cable, thus not at points, but as a continuous profile. A high accuracy of temperature.
[pdf] Although most people want to make measurement in units of dBm or Watts, an optical power meter is only capable of measuring either the current or the voltage generated by a photodetector. When interfacing with a photodiode, the quantity that must be measured is current. In fiber optics, lasers, sensors, and optical communication links, this measurement is central to confirming that signals are strong enough to perform reliably without overloading. Quantum efficiency is dependent on many factors, but in general if the energy of the photon, E = h v, is greater than the energy gap of the device, these photons will be absorbed very near the surface where the recombination rate is high and will contribute to the photocurrent.
[pdf] 
