To set up fiber optic internet on a Phicomm router, connect the fiber cable to an ONT, link the ONT to the router via Ethernet, and configure the router's WAN settings.

Step 1: Gather Required Equipment

• Optical Network Terminal (ONT): Provided by your ISP to convert fiber signals into Ethernet-compatible signals .
• Phicomm Router: Ensure it supports WAN connections via Ethernet .
• Fiber Optic Cable: Usually SC/APC or SC/UPC connectors .
• Ethernet Cable: To connect the ONT to the router .

Step 2: Install the ONT

1. Locate the fiber wall outlet where your ISP's fiber line enters your home .
2. Connect the fiber optic cable from the wall outlet to the ONT's optical port, handling the connector carefully to avoid dirt or damage .
3. Power on the ONT and wait for the status lights to stabilize (typically 2–5 minutes), .

Step 3: Connect the ONT to the Phicomm Router

1. Use an Ethernet cable to connect the ONT's LAN/Ethernet port to the WAN port on your Phicomm router .
2. Place both devices near a power outlet and in a dry, ventilated area .
3. Power on the router after the ONT is fully operational .

Step 4: Configure the Phicomm Router

1. Access the router's web management interface by entering 192.168.0.1 or 192.168.1.1 in a browser .
2. Log in using the default credentials provided in the manual.
3. Navigate to WAN/Internet settings and select the connection type recommended by your ISP (commonly PPPoE for fiber).
4. Enter your ISP-provided username and password.
5. Save the settings and reboot the router if necessary .

Step 5: Verify Connection

• Check the router's WAN and Internet status lights to confirm connectivity .
• Test internet access on a connected device.
• Optionally, configure Wi-Fi settings, QoS, or security features for optimal performance .

Troubleshooting Tips

• Ensure all cables are securely connected and free of damage .
• Power cycle the ONT first, then the router if the connection fails .
• Use the router's Health Check or diagnostics tool to verify WAN and Internet status .
• If issues persist, consult the Phicomm manual or contact your ISP for ONT-specific support . By following these steps, your Phicomm router should successfully connect to your fiber optic internet, providing high-speed and stable connectivity.